Skip to content
Call for a free quote
Industry

DPF cleaning for
construction.

Off-highway plant working low-speed, high-load cycles on site.

machine transport needed
0 km
Where
Nashik workshop
Measured
Before and after
Fleet rates
From 3 filters
On the bench

What construction filters look like when they reach us

Excavators, loaders and compactors spend most of their hours idling or at low load, which is the duty cycle a particulate filter was never designed around. Filters block on hours rather than kilometres, and the machine they came off is not going anywhere, so the filter travels alone. That suits the bench: the unit is removed during planned downtime, sent in, cleaned and measured, and back before the next shift that needs it.

Construction filters are among the four categories the rate card does not price, so the figure is indicative until the filter is measured. The before reading decides the quote, and a substrate that is cracked from an overheated regeneration is identified then rather than after cleaning.

Typical equipment

  • JCB backhoes and excavators
  • CAT and Komatsu excavators
  • Volvo CE loaders
  • SANY and XCMG cranes
Prices

What construction filters cost to clean

This sector is one the rate card prices after assessment: the figure below is indicative, and the bench measurement confirms it before any work.

From ₹19,500indicative

Construction Equipment: Excavators, loaders, dozers, cranes and compactors. 8 to 16 hours on the bench.

Full rate card by brand and the quote calculator for extras and fleet sizes.

Questions

Construction operators ask

Construction filters are quoted after assessment; the indicative figure on the rate card is from ₹19,500 per filter before GST. The exact price follows the bench measurement.

Remove it during planned downtime and courier it. Pack the ends and pad it like glass; the courier guide on the blog shows how. It comes back with the readings for refitting.

Hours. A site machine can block its filter in a few hundred hours of idling while the odometer barely moves. The fleet programme sets the interval from the engine-hour meter.

Next step

Running construction vehicles? Tell us the fleet.

Vehicle types, how many, and how they are used. You will get an interval, a price per filter with the fleet rate applied, and how the collection would work, before anything is removed.