DPF Removal & Installation
Most repeat DPF faults we see after third-party work trace back to refitment, not cleaning — a reused gasket, a cracked pressure line, a sensor left unseated. We treat the refit as a controlled procedure with a documented checklist, not an afterthought.
- Typical duration
- 2–5 hours
- Seals renewed
- 100%
- Torque recorded
- Every joint
- Leak tested
- Under load
What the job includes
Careful removal and reinstallation of the filter assembly, including gasket, clamp and sensor line renewal.
- Seized fastener extraction without collateral damage
- All gaskets, clamps and V-bands renewed as standard
- Pressure sensor lines inspected and cleared
- Torque-to-spec on every joint, recorded
- Post-fit leak test under load
- ECU adaptation values reset correctly
At a glance
- Duration
- 2–5 hours
- Indicative price
- Quoted per job
- Category
- Core DPF Services
- Written report
- Included
Prices are indicative and depend on vehicle, filter size and condition. You receive a firm figure after the diagnostic pass, before any work is authorised.
What you get back
Each of these is a figure we record and hand over in writing, not an estimate offered at the counter.
100%
Seals renewed
Every joint
Torque recorded
Under load
Leak tested
Every job runs through the same documented nine-step sequence, whichever service brought you in.
See the processOften needed alongside this
A blocked filter rarely has a single cause. These are the services most commonly carried out in the same visit.
Book dpf removal & installation
Tell us the vehicle, the symptoms and any fault codes on the dash. We will confirm whether this is the right service before you commit to it.