DPF Regeneration
A healthy diesel burns off accumulated soot continuously. When that stops happening, the filter loads faster than it can clear and the vehicle enters a cycle of warning lights and derates. We restore the conditions regeneration actually needs.
- Typical duration
- 2–4 hours
- From
- ₹3,500
- Cycle completion
- Verified live
- Soot load after
- Below 20%
What the job includes
Diagnosis and correction of the conditions that stop a filter from regenerating on its own.
- Verification of exhaust gas temperature targets
- Differential pressure sensor calibration
- Post-injection strategy and fuel trim review
- EGR flow and cooler condition assessment
- Driving-cycle guidance tuned to the vehicle duty cycle
- Regeneration completion confirmed on live data
At a glance
- Duration
- 2–4 hours
- Indicative price
- From ₹3,500
- Category
- Core DPF Services
- Written report
- Included
Prices are indicative and depend on vehicle, filter size and condition. You receive a firm figure after the diagnostic pass, before any work is authorised.
What you get back
Each of these is a figure we record and hand over in writing, not an estimate offered at the counter.
Verified live
Cycle completion
Below 20%
Soot load after
Included
Follow-up check
Every job runs through the same documented nine-step sequence, whichever service brought you in.
See the processOften needed alongside this
A blocked filter rarely has a single cause. These are the services most commonly carried out in the same visit.
Book dpf regeneration
Tell us the vehicle, the symptoms and any fault codes on the dash. We will confirm whether this is the right service before you commit to it.